215575 273 Revision B
Figure 5.121: Left Rear Deck
18. Place bearing support (B) on roller shaft (A).
19. Position the bearing assembly’s base against the frame, and
align the mounting holes.
Figure 5.122: Left Rear Deck
20. Install two M12 x 30 carriage bolts (A) in the upper holes
and two M12 x 40 carriage bolts (B) in the lower holes. The
bolt heads must face aft. Secure the bolts with M12
lock nuts.
NOTE:
Ensure that the height controller is not damaged when
installing bolts.
Figure 5.123: Left Rear Deck
21. Install lock collar (B) onto the bearing, and secure it by
rotating it clockwise.
22. Turn the roller manually until set screw (A) in lock collar (B)
lines up with the recess in bearing support (C).
23. Tighten set screw (A).
24. Align the draper deck rollers. Refer to Aligning Rear Draper
Deck Rollers, page 280 for instructions.
25. Install the hydraulic motor. Refer to Installing Rear
Hydraulic Motor, page 237 for instructions.
26. Tighten the draper belt.
27. Close the left endshield. For instructions, refer to 3.3.2
Closing Left Endshield, page 26.
MAINTENANCE AND SERVICING
To Next Page
Loading...
