2A-8 - INSTALLATION - ALPHA ONE DRIVES 90-823225--1 1096
WEBER 4 BARREL CARBURETOR
71159
b
a
Wide Open Throttle Position
a - Throttle Shaft Lever [Contacts (b) at W.O.T. Position]
b - Carburetor Body Casting
70392
b
a
Idle Position
a - Throttle Shaft Lever [Contacts (b) at W.O.T. Position]
b - Idle Speed Adjustment Screw
IMPORTANT: Do not attach any accessory
ground (–) wires to transom plate ground point.
Accessory ground wires should only be attached
to ground stud on engine.
6. Connect any grounding wires or accessories that
may have been disconnected.
7. Connect MerCathode wires to MerCathode con-
troller assembly as shown, if so equipped. Apply
a thin coat of Quicksilver Liquid Neoprene to all
connections.
22232
b
c
d
a
a - ORANGE Wire - From Electrode on Transom Assembly
b - RED/PURPLE Wire - Connect (Other End) to Positive
(+) Battery Terminal
c - BLACK WIRE - From Engine Harness
d - BROWN WIRE - From Electrode on Transom Assembly
IMPORTANT: Adjust shift cables as outlined in
appropriate Stern Drive Service Manual.
8. Refer to appropriate Stern Drive Service Manual
and install and adjust drive unit and remote con-
trol shift cables, using hardware retained.
IMPORTANT: After fluid hose installation in the
following, bleed power steering system as out-
lined in SECTION 1B - “Maintenance” or refer to
appropriate Stern Drive Service Manual.
To Next Page
Loading...
