ELECTRONIC FUEL INJECTION (MULTI-PORT AND THROTTLE BODY) - 5E-14590-823225--1 1096
2. Label and then disconnect all fuel lines from
cover of vapor separator tank.
3. Remove electrical line from retainer clip.
4. Remove cover screws and remove cover and
electrical line retaining clip.
5. Remove float arm pin retaining fastener and re-
move float and needle assembly.
6. Remove diaphragm cover screws and remove di-
aphragm cover, O-ring, diaphragm and spring.
CLEANING AND INSPECTION
1. Clean and inspect all parts. Check diaphragm for
damage. Replace if necessary.
2. Inspect spring for wear. Replace if necessary.
INSTALLATION
1. Install spring, diaphragm, O-ring and diaphragm
cover using diaphragm cover screws. Tighten
screws.
2. Install float and needle assembly and secure float
arm pin using fastener.
3. Apply Loctite 8831 to threads of cover screws.
Install cover and electrical line retainer clip and
tighten cover screws securely.
73895
1
4
6
2
3
5
Torque Sequence For VST
4. Secure electrical line in retainer clip.
5. Connect all fuel lines to cover of vapor separator
tank. Torque fuel line fittings to 23 lb. ft. (31 N·m).
6. Connect fuel pump electrical connector.
7. With engine OFF, cycle ignition switch to ON,wait
for 2 seconds, then OFF, four times, waiting 10
seconds after each key off to prime the fuel sys-
tem and check for leaks.
To Next Page
Loading...
