6B-14 - CLOSED COOLING MODELS 90-823225--1 1096
71150
a
a - Impeller
3. Slide impeller and pump body assembly onto
shaft. Position pump body so that holes align with
holes in wear plate, gasket and bearing housing.
Install rubber plug into end of impeller.
4. Coat both sides of new cover gasket and wear
plate gasket with a thin film of Quicksilver Perfect
Seal. Install outer wear plate with new gaskets on
each side, aligning holes in plate and gaskets
with holes in pump body.
72652
b
c
a
a - Gasket (with Large Opening)
b - Wear Plate (Outer)
c - Gasket (with Two Openings)
72651
b
c
a
a - Gasket (with Large Opening)
b - Wear Plate (Outer)
c - Gasket (with Two Openings)
5. Install pump cover and secure with five bolts and
washers. Torque bolts to specifications.
SEAWATER PUMP REASSEMBLY
(ONE PIECE BODY)
1. Lubricate seawater pump impeller with a water
and soap solution. Install impeller into housing by
rotating and pushing it into place. Push it down
until flush with housing.
71118
71150
a
a - Impeller
To Next Page
Loading...
