CLOSED COOLING MODELS - 6B-1590-823225--1 1096
2. Place wear plate over bearing housing shaft.
3. Place quad ring in groove in seawater pump
body.
b
a
a - Quad Ring
b - Seawater Pump
4. Align flats on impeller and bearing housing shaft,
slide seawater pump body on shaft.
5. Install two screws in seawater pump body holes
as shown. Use these two screws to align pump,
then install the remaining screws.
75277
a
a
a - Bolt Holes For Alignment
INSTALLATION
1. Position pump in mounting bracket so that outlet
connection will be directly above inlet connection
when pump is installed.
IMPORTANT: Pump must be positioned correctly
or overheating of engine may occur.
72666
72667
a
a - LH Out - At Top
IMPORTANT: Flat washer must be installed be-
tween mounting bracket clamping bosses or
damage to pump may result (if clamping screw is
over-tightened).
To Next Page
Loading...
