Minebea Intec X3 - Page 30

3.4.4.5.1 Selecting parameters
The selection and modification of parameters are described in the following.
1. Press
.
SEtuP appears on the display.
2. Press /OK.
The "Cd" calibration menu flashes.
Cd 000 appears on the display.
3. Press to access the next parameter group.
CP flashes on the display.
4. Press to access the parameter number.
CP 010 appears on the display. The right digit flashes.
5. Press
/ to select the digits.
6. Press / to increase/decrease the number.
7. Press
/OK to select the menu item.
The menu item appears on the display.
8. Press /OK to switch to the parameter selection.
9. Press / to select the parameter values.
10. Press /OK to select the parameter values.
11. Press "Exit" to exit a menu.
appears on the display.
If a parameter was changed, SAVE
12. Press
/OK.
YES appears on the display.
13. Press if necessary, to select "no."
14. Press /OK to save the change.
X3 Process Indicator PR 5410 3 Device description
EN-28 Minebea Intec