Issue 1.2 UNIVERGE SV9100
5 - 84 Installing DT Series Digital and IP Multiline Terminals
3. Remove the screw (refer to Figure 5-83 Remove
Side Panel from Multiline Terminal on page 5-83).
4. Carefully, return the multiline terminal to the buttons
side up position.
5. Remove the soft keys and line key kit from the
telephone.
6. Gently lift the small black bar to open the ribbon
cable connector.
7. Plug ribbon cable on back of 8LKI (LD)-L UNIT into
connector (metal side down) until pressure is felt.
8. Press down on the black bar to lock the cable into
place (refer to Figure 5-85 Ribbon Cable Installed
on page 5-85).
Figure 5-84 Ribbon Cable Connector
To Next Page
Loading...
