Issue 1.2 UNIVERGE SV9100
6 - 42 Installing SV9100 Optional Equipment
12. Plug the end of the line cord for the analog device which has
the ferrite bead closest to it into the jack on the adapter.
Connect the opposite end to the analog device.
13. To determine the APR analog extension number. . .
10-03-04 : Optional Installed Unit 1
Displays the type of terminal installed. This can be used to
verify that the system recognizes the adapter.
10-03-06 : Blade Setup
Assign the terminal type (12) for the telephone channel, which
has the APR Adapter installed.
When you want the APR to use the same extension number as
the telephone to which it is attached, remove the terminal type
in this option. With this setup, when the analog device is in use,
it busies out the terminal as there is no separate port number
assigned for the adapter. To reverse this, and allow the APR to
have its own extension number, reassign the terminal type (12)
in this option.
10-03-07 : Blade Setup
The port number of the APR Adapter is displayed for the
extension (APR ports = 193-256 with all software through
3.07). The ports are assigned from the highest available port
down.
Refer to Section 5: Data and SMDR for additional details.
Figure 6-33 Ferrite Bead with APR Adapter
Before removing the adapter, to avoid any
hardware problems, unplug the line cord, then
any other adapter cables.
To Next Page
Loading...
