NSK Megatorque PS Series - Page 282

— 9-58 —
Ì P PP: Parameter Prompt
 There are two prompts for programming to distinguish which parameter is effective: the local
parameter that is changed especially for a program channel or the global parameter that is set by
the normal prompt.
◊ “:” : Global parameter is effective.
◊ “: >” : Local parameter is effective.
When the parameter is set via RS-232C communication, both parameters,
global and local, are set to the channel, even the prompt is “:>”.
 Setting the parameter PP0 will make possible not change the prompt.
◊ Refer to “6.3.2.2. Program Positioning Operation via RS-RS-232C Communication”
for details.
Category Parameter
Format
PP data
0
: Does not change the prompt. (Always “:”)
Data range
1
: Indicates the effective parameter. (“:” of “: >”)
Shipping set 1
Ì P PS: Position Scale Select
 This parameter specifies the position scale system.
Category Parameter
Format
PS data
Data range 1
: One revolution position scale
Shipping set 1
PWU: (Factory use only)
 This monitor is for factory use only.
PWV: (Factory use only)
 This monitor is for factory use only.
PWW : (Factory use only)
 This parameter is for factory use only.