NSK Megatorque PS Series - Page 301

— 9-77 —
WTV: (Application use only)
 This parameter is used only for the EDC MegaTerm. Do not change the setting.
WVA: (Application use only)
 This parameter is used only for the EDC MegaTerm. Do not change the setting.
WVB: (Application use only)
 This parameter is used only for the EDC MegaTerm. Do not change the setting.
WVC: (Application use only)
 This parameter is used only for the EDC MegaTerm. Do not change the setting.
WVD: (Application use only)
 This parameter is used only for the EDC MegaTerm. Do not change the setting.
WWC: Multi- monitor clear
 This command cancels the multi-monitor function.
◊ Refer to “4.4.1. Input a Command Monitoring Multiple Conditions of the System” for
details.
Category Command
Format
WWC
ÌÌ XDB: (Factory use only)
 This parameter is for factory use only. Do not change the setting,
ÌÌ XDM: (Factory use only)
 This parameter is for factory use only. Do not change the setting,
ÌÌ XIE: (Factory use only)
 This parameter is for factory use only. Do not change the setting,
ÌÌ XIG: (Factory use only)
 This parameter is for factory use only. Do not change the setting,