NXP Semiconductors MC9S12G - Page 1191

Electrical Characteristics
MC9S12G Family Reference Manual Rev.1.27
NXP Semiconductors 1193
Table A-15. Run and Wait Current Characteristics (Junction Temperature From –40C To +150C)
DBG
The module is enabled and the comparators are configured
to trigger in outside range.The range covers all the code
executed by the core.
TIM
The peripheral shall be configured to output compare mode,
pulse accumulator and modulus counter enabled.
COP & RTI Both modules are enabled.
ACMP
1
The module is enabled with analog output on. The ACMPP
and ACMPM are toggling with 0-1 and 1-0.
DAC
2
DAC0 and DAC1 is buffered at full voltage range
(DACxCTL = $87).
RVA
3
The module is enabled and ADC is running at 6.25MHz with
maximum bus freq
1
Onlly available on S12GN16, S12GN32, S12GN48, S12G48, and S12G64
2
Only available on S12G192, S12GA192, S12G340, and S12GA240
3
Only available on S12GA192 and S12GA240
Conditions are: V
DDR
=5.5V, T
A
=125C, see Table A-13. and Table A-14.
Num C Rating Symbol Min Typ Max Unit
S12GN16, S12GN32
1 P IDD Run Current (code execution from RAM) I
DDRr
12.5 16 mA
2 C IDD Run Current (code execution from flash) I
DDRf
13 17 mA
3 P IDD Wait Current I
DDW
7.2 10 mA
S12GN48, S12G48, S12G64
4 P IDD Run Current (code execution from RAM) I
DDRr
14 19 mA
5 C IDD Run Current (code execution from flash) I
DDRf
15.5 20 mA
6 P IDD Wait Current I
DDW
8.7 11 mA
S12G96, S12G128
7 P IDD Run Current (code execution from RAM) I
DDRr
15 21 mA
8 C IDD Run Current (code execution from flash) I
DDRf
17 22 mA
9 P IDD Wait Current I
DDW
911.5mA
S12G192, S12GA192, S12G240, S12GA240
10 P IDD Run Current (code execution from RAM) I
DDRr
18 22.5 mA
11 C IDD Run Current (code execution from flash) I
DDRf
17 23.5 mA
12 P IDD Wait Current I
DDW
9.5 12 mA
Table A-14. Peripheral Configurations for Run & Wait Current Measurement
Peripheral Configuration