Analog-to-Digital Converter (ADC10B16CV2)
MC9S12G Family Reference Manual Rev.1.27
NXP Semiconductors 509
15.1.2 Modes of Operation
15.1.2.1 Conversion Modes
There is software programmable selection between performing single or continuous conversion on a
single channel or multiple channels.
15.1.2.2 MCU Operating Modes
• Stop Mode
Entering Stop Mode aborts any conversion sequence in progress and if a sequence was aborted
restarts it after exiting stop mode. This has the same effect/consequences as starting a conversion
sequence with write to ATDCTL5. So after exiting from stop mode with a previously aborted
sequence all flags are cleared etc.
• Wait Mode
ADC10B16C behaves same in Run and Wait Mode. For reduced power consumption continuous
conversions should be aborted before entering Wait mode.
• Freeze Mode
In Freeze Mode the ADC10B16C will either continue or finish or stop converting according to the
FRZ1 and FRZ0 bits. This is useful for debugging and emulation.
To Next Page
Loading...
Need help?
General
