Olympus EPOCH 1000 Series - Page 357

910-269-EN, Rev. B, June 2011
Index 345
electrical shock, danger note 4, 29
EMC directive compliance 10
EN12668-1 and filter set 99
entering
text information 178
environmental ratings 37, 312
EP-MCA, use only with EPOCH 1000 44
error message no active ID, note 182
[Escape] key 22
exit with cancel box, note 139, 143, 148, 153,
159, 165, 280, 292
F
FCC (USA) compliance 10
feature activation 198
features
hardware 19
licensed and unlicensed 195
software 49
file type
INC 187
filter
adjusting 97
advanced set 98
custom sets 100
digital 251
digital receiver 97
group, adjusting 97
set and EN12668-1 99
standard set 97
first back-wall echo
in gate, note 291
note 142
first signal saturation, tip 151
flags 59
flank measurement mode 60
flank mode 114
floating gate
–14 dB mode 237
–6 dB mode 236
alarms 238
and RF mode, note 238
licensed option 195
option activation 235
software option 235
[Fn] function keys 21, 23
focal law
range and resolution 243
selection cursor, adjusting 255
freeze
disabling 105
display 263
front panel user interface 20, 21
frozen display trouble shooting 309
full file content review, accessing 183
function [Fn] keys 21, 23
G
GageView 86
measurement schemes 71
part numbers 332
gain
adjustment options 206
coarse adjustment, note 91
curve saturation, note 288, 301
gasket 36
gate
adjustment during calibration 303
alarms 120
captures all focal laws, important note 286,
289, 299, 302
conventional UT mode 109
interface 113
measurement 1 and 2 110
measurement modes 113
PA mode 269
specifications 314
tracking measurements 116
[GATE] key
and previous group menu, note 113
for current gate only, note 112
general purpose keys 22
general setup menu 76
general warning symbol 6
geometry, material 242
getting started
calibration in conventional UT mode 134
calibration in PA mode 275
glossary 323
GND ground 316
grid mode 266
100% or 110% 108
Downloaded from ManualsNet.com search engine