910-269-EN, Rev. B, June 2011
350 Index
adding 91, 232
scheme for scan, color 256
screen capture storage, note 191
seals, membrane 36
selecting PRF adjustment method 92
sensitivity
calibrating 160
calibration with a zero degree transducer 286
multiple point 278
single (Gain) 278
sensitivity calibration
PA mode 277
sensitivity calibration with an angle beam
transducer 299
serial communication 131
serial number format 3
setting
conventional UT mode
before calibrating 134
minimum depth alarm 122
phased array mode before calibrating 276
threshold alarm 121
side-drilled hole wedge delay calibration, note
285
signal word
caution 7
danger note 7
important note 8
note 8
tip 8
warning note 7
single shot instrument, note 93
software
features 49
features (UT) 195
licensed and unlicensed features 195
serial number 79
version 79
software option
activating 196
activation gate 234
AWS D1.1 229
conventional UT mode 195
floating gate 235
sound path
distance, calibrating 157
grid mode 107
spare parts 332
S-scan curved grid, note 267
stand 35
back 20
bottom 36
rear 36
standard filter set 97
standard grid mode 107
standard wedges and materials, note 243
status menu 79
storing Ref B value 230
straight beam modes 136
straight-beam transducer, calibrating using a
137
support information 11
symbol
C-Tick (Australia) 2
direct current 2
high voltage warning note 7
RoHS 2, 10
warning note 6
WEEE 2
system sensitivity adjusting 89
T
table, TCG 214
technical support 11
temporary scanning gain, adding 207
test block 168
IIW Type 1 V1 171
test mode, adjusting 95
text information, entering 178
thickness measurement
non-linear with dual transducer, note 146
thin material and transducer frequency, note
137
threshold alarm 120
setting 121
thumb screws, battery compartment cover 33
time, internal clock 77
time-of-flight mode 118
time-varied gain (TVG) 197
tip
accurate curve acquisition 284, 288, 297, 301
auto measurement reading 135
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
