910-269-EN, Rev. B, June 2011
Index 351
auto-calibration and single thickness test
block 140
calibration full coverage 276
coarse/fine mode 24
DAC curve to 80% FSH 200
damping 94
expand range 135
first back-wall echo in gate 291
first signal saturation 151
increase range to view echoes 203
order of calibration 302
peak memory 156, 161, 163
and beam index point 155
signal word 8
TOF time-of-flight 118
trademark disclaimer ii
transducer life, note 249
transfer correction
adjusting, note 226
to a completed DAC curve, adding 210
to a completed DGS/AVG curve, adding 226
transit time, through transmission 95
transmit/receive conventional connectors 28
trigger input and output 130
trouble shooting 308
note 193
true-depth and sound path gates, note 270
turning on or off grid mode 266
TVG setup with TVG table, building 217
TVG table 214
building a TVG 216
customized setup 215
setup 215
typographical conventions 16
U
ultrasonic velocity in materials 321
[UP] key 22
USA FCC compliance 10
USB
client 131
communication 131
host 131
host port in battery compartment 33
keyboard and mouse control 27
USB client connector 34
USB hosts connector 34
use only EPXT-BAT-L batteries, warning note
43, 44, 46
user interface
front panel 20, 21
using
AC power line 42
AUTO-XX% feature 90
V
velocity calibration
PA mode 276
with a zero degree transducer 279
with an angle beam transducer 290
velocity in materials 321
vent, membrane 20
verifying
o-ring gaskets and seals 307
refracted angle 156
VGA output
output
VGA 127
video filtering
caution note 251
note 250
video output connector 34, 128
viewing digital measurements 116
voltage, pulser 248
W
warning note
electrical 9
general 8
high voltage symbol 7
signal word 7
symbol 6
use EP-MCA only with EPOCH 1000 44
use only EPXT-BAT-L batteries 43, 44, 46
warranty information 11
waste electrical and electronic equipment 9
waveform rectification 99, 249
wedge
selection 241
supported (PA mode) 318
wedge delay calibration
PA mode 277
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
