Philips Expression MR400 - Page 53

ExpressionMR400InstructionsforUseImportantInformation1‐31
3 Enterthenetworkchannelchangemode:Afterthecurrent
networkchannelindicatorhasbeenilluminated(andwithin10
secondsofmodulepower‐up),pressandholdthenetwork 
selectionbuttonuntilthecurrentnetworkchannelindicatorbegins
torapidlyblinkthenrelease
thebutton.
Note
If the network channel change sequence was not started within 10
seconds after the module has been turned on, network channel
changes will not be allowed. In this case, you must cycle module
power and restart the sequence.
4Pressdownagainonthenetworkselectionbuttonuntilthesymbol
stopsblinkingandthenreleasethebuttontochangethenetwork 
channelsetting.
Whenyoudothis,thenextnetworkchannelindicatorinthe
sequencewillblinkrapidly.(Inotherwords,ifthemodulewas
originallyusingnetworkchannel
“3,”nowthe“4”symbolwillbe
blinking.)Repeatthissequenceofpressingdownandreleasingthe
buttonuntilthesymbolofthenetworkchannelyoupreferis
rapidlyblinking.Ifyoupassthedesired channel,simplycontinue
pressingandreleasingthebuttonuntilthedes irednetwork
channelindicatorisblinking
again.
Step Action