4535 612 10261 HD11 Service Manual Page 101
CSIP Level 1 Installation: Presenting the System
• Demonstrate how to clean the air filter and explain the importance of a clean filter to
system performance.
• Explain why it is important for them to never remove covers from the system because of
ESD and warranty considerations.
• If the system is connected to a DICOM network, show the customer the Job Manager.
Explain that the user should check the Job Manager at the end of each day and that an empty
queue indicates that all studies have been successfully transferred to the DICOM PACS.
• Review with the customer, procedures for placing service calls or calling for technical
assistance.
NOTE These are shortcut control key functions you may want to note and share with the cus-
tomer (those that are found in Help under “Using the Control Panel”): Press Ctrl+b to
change the backlight level; press Ctrl+j to go to the DICOM Job Manager; press
Ctrl+q to cycle through the Autotrace Evaluation settings; press Ctrl+u to add a
user-mark to the event log; and press Ctrl+Alt+s to enter simulation mode (only dur-
ing power-up).
To Next Page
Loading...