4535 612 10261 HD11 Service Manual Page 126
CSIP: Level 2 Installation: Physical Installation Procedures
Figure 5-34 Installing the Peripheral Covers (Garages)
14
15
14
Hole (4 plcs)
15
Tab (4 plcs)
16
System not shown for clarity
14. Place the garages over the peripher-
als.
15. Line up the holes on the plate with
the tabs on the bottom of each
garage.
16. Gently press down on all four cor-
ners of the garage to snap it into
place.
This completes the dual peripheral
mounting plate installation procedure.
NOTE These steps are also valid for
the single (small) peripheral
mounting plate installation.
Return to Installation Procedure List.