Philips HD11 - Monitor; Figure 10-8 Removing the Video Monitor

4535 612 10261 HD11 Service Manual Page 195
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
Monitor
Figure 10-8 Removing the Video Monitor
4
Latch handle
4
5
➤ To remove the system monitor
1. Disconnect the system power cord
from the main AC supply.
2. Remove the cable connection access
panel (Figure 5-22).
3. Disconnect all the monitor cables
(Figure 5-24).
4. Press up on the latch handle under
the front edge of the monitor and
pull the monitor forward until it
stops.
5. Tilt up the front of the monitor and
lift the monitor off the twivel base.
Perform the Monitor installation proce-
dure for reassembly.
Perform all system checks to verify per-
formance.
Return to Disassembly Procedure List (1
of 2).