4535 612 10261 HD11 Service Manual Page 194
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
Figure 10-7 Removing the Side and Rear Base Skirts
10
Torx screws (2 plcs)
10
Torx screws (2 plcs)
11
To r x s c re w s
(4 plcs)
NOTE Any of the base skirts can be
removed without removing any
other system enclosures.
10. To remove either of the side base
skirts, remove the two Torx screws
securing the skirt to the base of the
cart.
11. To remove the rear base skirt,
remove the four Torx screws secur-
ing the skirt to the base of the cart.
This completes the system enclosures
removal procedure.
Perform this procedure in reverse for
reassembly.
Return to Disassembly Procedure List (1
of 2).
To Next Page
Loading...