4535 612 10261 HD11 Service Manual Page 94
CSIP Level 1 Installation: Powering On and Configuring the System
Verifying t he
System Options
The system leaves the factory with all purchased options enabled. Verify that the options enabled
are the options that the customer ordered.
You must have the correct authorization code to enable system options in the field.
➤ To verify or enable system software options
1. Press Setup.
The Setup window opens (Figure 5-1).
2. Click the Options tab (Figure 5-8).
3. Click Options to open the system options view, install, and remove tool (Figure 5-9).
NOTE Information about the system is provided in the banner of the tool window. It is neces-
sary to have the system serial number when requesting option authorization codes.
4. To install or remove an option, select the item from the Application column and click Install,
Install From File, or Remove and respond to the prompt.
To Next Page
Loading...