4535 612 10261 HD11 Service Manual Page 243
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
Power Supply
Figure 10-56 Removing the Right Side Panel
To r x s c r e w s
(2 plcs)
1
2
3
➤ To remove the power supply
1. Disconnect the system power cord
from the main AC supply.
2. Remove the two Torx screws secur-
ing the right side panel enclosure.
Removing this panel allows access to
the E-box and power supply assem-
blies.
3. Pivot the back side of the panel away
from the system, and then gently
slide the panel toward the rear to
remove it. Proceed to step 4.
To Next Page
Loading...