4535 612 10261 HD11 Service Manual Page 216
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
PC Assembly
Figure 10-29 Disconnecting the PC Cables
1
2
PC assembly
➤ To remove the PC assembly
1. Disconnect the system power cord
from the main AC supply.
First, refer to the System Enclosures
procedure and perform all steps before
proceeding.
Next, refer to the To remove the B&W
printer procedure and perform all steps
before proceeding.
2. Disconnect all cables from the rear
of the PC assembly. Note their loca-
tions so you can reinstall them prop-
erly. Refer to Figure 11-1 and
Figure 11-2 for signal and power
cabling diagrams. Proceed to step 3.
To Next Page
Loading...