Philips HD11 - Rear I;O Assembly and Video I;O Board; Figure 10-62 Removing the Left and Right Side Panels

4535 612 10261 HD11 Service Manual Page 249
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
Rear I/O Assembly and Video I/O Board
Figure 10-62 Removing the Left and Right Side Panels
To r x s c r e w s
(2 plcs)
3
4
1
2
NOTE Both side panels must be
removed before removing the
rear I/O assembly.
1. Disconnect the system power cord
from the main AC supply.
2. Remove the two Torx screws secur-
ing the left side panel enclosure.
3. Pivot the back side of the panel away
from the system, and then gently
slide the panel toward the rear to
remove it.
4. Repeat step 2 and step 3 for right
side panel removal. Proceed to
step 5.