4535 612 10261 HD11 Service Manual Page 209
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
B&W Printer
Figure 10-22 Removing the Top Cover with a Mounting
Plate Bracket
Torx screws
(6 plcs)
1
Mounting plate bracket
2
➤ To remove the B&W printer
NOTE Refer to Figure 10-3 and
Figure 10-4 for left/right side
panel removal.
1. Remove the six Torx screws securing
the mounting plate bracket to the
top cover. Remove the mounting
bracket.
2. These six Torx screws also secure
the top cover. Feed the cables
through the top cover opening, then
lift and slide the top cover toward
the rear of the system. Proceed to
step 3.
To Next Page
Loading...