4535 612 10261 HD11 Service Manual Page 242
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
Figure 10-55 Removing the Backplane Board
Left side panel not
shown for clarity
Torx screws
(6 plcs)
6
7
6. Remove the six Torx screws securing
the Backplane board to the inside of
the E-box assembly.
7. Slide the Backplane board out of the
E-box card cage.
This completes the Backplane board
removal procedure.
Perform this procedure in reverse for
reassembly.
Return to Disassembly Procedure List (2
of 2).
To Next Page
Loading...