4535 612 10261 HD11 Service Manual Page 260
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
Figure 10-73 Inserting the Gas Strut onto the Ball Stud
15
Ball stud
14
14
13
13. Press the gas strut ball socket onto
the ball stud.
14. Insert the keeper pin through the
two holes in the ball socket.
15. Rotate the keeper pin (clockwise)
around the shaft and snap it into
place.
This completes the gas strut removal
and reassembly procedure.
Return to Disassembly Procedure List (2
of 2).
To Next Page
Loading...