4535 612 10261 HD11 Service Manual Page 162
CSIP Level 1 Adjustments: Adjusting the Monitor
Adjusting the
Monitor
BRIGHTNESS and
CONTRAST
Range
There is a tool for setting the range of the monitor brightness and contrast controls.
➤ To set the monitor BRIGHTNESS and CONTRAST range
1. In the Setup window, click Monitor Adjust. The system displays the BRIGHTNESS and
CONTRAST range adjust tool.
2. Follow the instructions on the screen to set the monitor BRIGHTNESS and CON-
TRAST range.
Adjusting the
Monitor Signal
Input Voltage
Submenus of the OSD Main Menu control the size and geometry of the display and set the mon-
itor’s signal input voltage.
➤ To verify the monitor signal input voltage setting
1. Remove the monitor cable connection access panel (Figure 5-22) and disconnect the power
cord from the rear of the monitor.
2. Hold down the two rightmost monitor buttons and reconnect the power cord. Continue
holding the buttons until you again see the screen that was displayed when you unplugged the
monitor. (This needs some patience, as it does not always happen easily.)
3. Simultaneously press the two center monitor buttons. The OSD Main Menu appears
(Figure 7-1).
NOTE Do not press the two center buttons for longer than 10 seconds or the OSD menu
locks and you will not be able to make any adjustments. To unlock the menu, press the
two center buttons for more than 10 seconds or until the “unlocked” message appears
and then release the buttons. Press the buttons again until the Main Menu appears.
To Next Page
Loading...