4535 612 10261 HD11 Service Manual Page 90
CSIP Level 1 Installation: Powering On and Configuring the System
2. In the Installed services section, add or remove input languages.
3. To modify the input language features, highlight the keyboard icon and click the
Properties button.
4. Click OK when you are finished.
Verifying t he
System
Language
Unicode
➤ To check or set the system language unicode
1. In the Regional and Languages Options window (Figure 5-3), click the Advanced tab.
The (Advanced) Regional and Languages Options Window window opens (Figure 5-5).
2. Click the Language for non-Unicode programs list and select the language. The selection
should be the one that most closely matches the chosen interface language.
3. Click OK to close the Regional and Languages Options window.
NOTE After any change to settings in the Regional and Language Options window, reboot the
system. You may be prompted to restart or to “use existing files.” Click Ye s in either
case.
If the customer’s language... Then install the...
is represented on the United
States-International keyboard
English (United States)-US keyboard only.
Set the default input language to English (United
States).
is not represented on the United
States-International keyboard
English (United States)-US keyboard and the
customer-requested input language.
Set the default input language to the
customer-requested language.
To Next Page
Loading...