4535 612 10261 HD11 Service Manual Page 98
CSIP Level 1 Installation: Preparing the Peripherals
NOTE When entering the number of pixels for DICOM printers (see Help topic: “Configuring
a New DICOM Printer”) and using the printer catalog, remember that the catalog con-
tains incorrect data for some of the printers. After entering the “Resolution” value
from the spreadsheet and checking Derive number of pixels from Film Size and
Resolution, note the values provided in the X and Y boxes and compare them to the
X and Y values in the spreadsheet. If the values are within 10% of each other, then
deselect the check box, and enter the X and Y values from the spreadsheet.
Configuring
Other System
Settings
If appropriate for this installation, work with the customer and follow the respective instructions
in Help to initially configure the system settings not yet set to the customer’s preference.
➤ To configure other system settings
1. Press ? Help on the soft key panel after you have the system running and click the Contents
tab and then “Customizing Your System.”
2. Select “System Settings” from the Help contents.
Preparing the
Peripherals
As applies, correctly load paper and ribbon in the printers and insert a tape cassette in the VCR.
Follow the respective instructions in Help to check or initially configure the system setups for
the peripheral devices. Press ? Help on the soft key panel after you have the system running and
select “HD11 System Overview” and then “Peripheral Devices” from the Help contents.
The system is configured at the factory for NTSC format. To reconfigure the system for PAL for-
mat, complete the following steps:
➤ To configure the system for PAL format
1. In the Setup window, click the Peripherals tab.
2. Click Install Software Drivers. The Install Software Drivers window opens.
To Next Page
Loading...