Philips HD11 - Figure 10-51 Removing the Signal Distribution Board

4535 612 10261 HD11 Service Manual Page 238
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
Figure 10-51 Removing the Signal Distribution Board
Torx screws
(8 plcs)
10
Right side panel not
shown for clarity
10. Remove the eight Torx screws secur-
ing the Signal Distribution Board to
the inside of the E-box assembly.
11. Lift and swing the bottom of the Sig-
nal Distribution Board outward to
remove it from the E-box assembly.
This completes the Signal Distribution
Board removal procedure.
Perform this procedure in reverse for
reassembly.
Return to Disassembly Procedure List (2
of 2).