4535 612 10261 HD11 Service Manual Page 118
CSIP: Level 2 Installation: Physical Installation Procedures
Single Peripheral (Color Printer)
Figure 5-26 Color Printer Installation
1
2
3
4
➤ To install the color printer (as a
single peripheral)
Refer to “Dual Peripherals” on page 120
for installation of the color printer with a
VCR.
1. Open the straps on the short periph-
eral mounting plate that comes
installed from the factory.
2. Strap the color printer to the
mounting plate, tighten the straps,
and secure the straps with the Velcro
end.
3. Connect the system color printer
cables in accordance with the color
printer cabling diagram (Figure 11-6).
Dress the unused cables.
4. If there is a peripheral cover
(garage), snap it into place over the
printer.
This completes the printer procedure.
Return to Installation Procedure List.
To Next Page
Loading...