4535 612 10261 HD11 Service Manual Page 339
CSIP Level 1 Configuration: BIOS Settings
Viewing and
Adjusting BIOS
Settings
Use the information in this section to view the BIOS settings (Table 13-2). You will need to verify
and possibly restore the BIOS, after changing the CMOS battery or Motherboard (Figure 13-4).
The system boot-up sequence is dictated by the corresponding BIOS setting, which can be
changed if necessary.
Restoring the BIOS Settings to Default Values
➤ To view (and restore) the BIOS settings
1. Reboot the system.
2. As the system boots up, press Report repeatedly, until the BIOS screen opens.
3. View the BIOS settings, comparing them to the factory default exceptions listed in
Table 13-2.
4. Reset the BIOS to the default settings by pressing the Option key and in the box that
appears, selecting Yes, and then pressing Return.
5. Set the system date and time to the local time by pressing the down arrow key until System
Time is highlighted. Refer to the descriptions in the right pane to make the appropriate
changes.
6. Press the right arrow until Advanced is highlighted, press the down arrow until Boot
Configuration is highlighted, press Return, and then set Plug and Play = Yes.
7. Press THI to return to the Advanced menu.
8. Press the down arrow until Peripheral Configuration is highlighted and press Return.
9. Refer to the descriptions in the right pane to set the following:
NOTE The Enter key that is referred to in the right pane is the Return key on the system
QWERTY keyboard.
1
To Next Page
Loading...