4535 612 10261 HD11 Service Manual Page 340
CSIP Level 1 Configuration: BIOS Settings
- Serial Port A = Enabled
- Serial Port B = Enabled
- Parallel Port = Disabled
- Legacy USB Support = Enabled
10. Press THI to return to the Advanced menu, press the right arrow until Boot is highlighted,
and then press Return.
11. Under the Boot menu, set: USB Boot = Disabled.
12. Press the down arrow until Boot Device Priority is highlighted and then press Return.
13. Refer to the descriptions in the right pane to set the following:
- First Boot Device = CD Drive
- Second Boot Device = Hard Disk Drive
- Third Boot Device = Disabled
- Fourth Boot Device = Disabled
14. Press THI to return to the Boot menu, press the left arrow until Power is highlighted.
15. Press the down arrow until After Power Failure is highlighted.
16. Refer to the descriptions in the right pane to set it to Stay Off.
17. Press the Option key, highlight Yes, and then press Enter to save the BIOS setting.
The system reboots.
2
To Next Page
Loading...