4535 612 10261 HD11 Service Manual Page 181
CSIP Level 1 Troubleshooting: Backing Up and Restoring
Backing Up
and Restoring
Before you begin installing software, replacing an HDD, or taking any service action that might
cause data to be lost, perform the following tasks:
• Ensure that the customer has saved any important studies.
• Make a backup CD of the system software options and custom presets. See “Creating a
Backup CD” on page 181.
• If the system is configured for network connection, write down the network settings. See
“Recording the Network Settings” on page 183.
Creating a Backup CD
➤ To create a backup CD
1. Start the system.
2. Insert a blank CD-R (or CD-RW) disk in the CD-writable drive.
3. With the ultrasound application running, press the Setup key. The Setup window opens
(Figure 5-1).
4. Click the CD tab. The Settings (CD) window opens (Figure 9-1).
5. Click Backup. The Backup Settings window opens (Figure 9-2).
6. Click Select All.
7. Click Start.
The backup procedure runs. When the procedure is done, the Backup Settings window
closes.
NOTE While it backs up the presets, the backup program also automatically backs up the sys-
tem settings, the peripheral settings, and the installed options.
To Next Page
Loading...