4535 612 10261 HD11 Service Manual Page 119
CSIP: Level 2 Installation: Physical Installation Procedures
Single Peripheral (VCR)
Figure 5-27 VCR Installation
1
2
3
4
➤ To install the VCR (as a single
peripheral)
Refer to “Dual Peripherals” on page 120
for installation of the VCR with a color
printer.
1. Open the straps on the short periph-
eral mounting plate that comes
installed from the factory.
2. Strap the VCR to the mounting
plate, tighten the straps, and secure
the straps with the Velcro end.
3. Connect the system VCR cables in
accordance with the VCR cabling
diagram (Figure 11-4). Dress the
unused cables.
4. If there is a peripheral cover
(garage), snap it into place over the
VCR.
This completes the VCR procedure.
Return to Installation Procedure List.
To Next Page
Loading...