Philips HD11 - Figure 10-65 Removing the Rear I;O Faceplate

4535 612 10261 HD11 Service Manual Page 252
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
Figure 10-65 Removing the Rear I/O Faceplate
Rear I/O faceplate
15
17
16
Video I/O
board
Standoff screws (4 plcs)
Nut and washer (3 plcs)
15. Remove the four standoff screws
securing the two Video I/O board
connectors to the Rear I/O face-
plate.
16. Remove the three nuts and washers
securing the three Video I/O board
BNC connectors to the Rear I/O
faceplate.
17. Remove the Rear I/O faceplate by
sliding it off of the Video I/O board
connectors. Proceed to step 18.