Philips HD11 - Figure 10-46 Removing the E-box Boards

4535 612 10261 HD11 Service Manual Page 233
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
Figure 10-46 Removing the E-box Boards
Power supply
ribbon cable
6
Signal processor
board connector
Card retainer
7
8
8
6. To remove the Signal Processor
Board, disconnect the power supply
ribbon cable from the Signal Proces-
sor Board connector.
7. To remove the Motor Controller or
one of the TR boards from the E-box
assembly, pull the card retainers out-
ward till you feel the board release
from the backplane board.
8. Carefully slide the board(s) out of
the card cage and place them on a
static-dissipating mat.
This completes the E-box boards
removal procedure.
Perform this procedure in reverse for
reassembly.
Return to Disassembly Procedure List (2
of 2).