Philips HD11 - Figure 5-31 Installing the Strapping on the Dual Mounting Plate

4535 612 10261 HD11 Service Manual Page 123
CSIP: Level 2 Installation: Physical Installation Procedures
Figure 5-31 Installing the Strapping on the Dual Mounting
Plate
Rear of system
Dual peripheral mounting plate
Straps (2 per device)
Plate strap slot
6
Cable slot (4 plcs)
VCR
Color
printer
7
NOTE The peripherals can be
mounted facing either side of
the system depending on the
user’s preference. The VCR
always mounts on the rear sec-
tion of the dual peripheral
mounting plate.
6. Thread the VCR and color printer
straps through the appropriate slots
in the dual peripheral mounting
plate.
7. Temporarily loop the straps and
secure with the Velcro end until the
dual peripheral mounting plate is
secured in place. Proceed to step 8.
NOTE These steps are also valid for
the single (small) peripheral
mounting plate installation.