4535 612 10261 HD11 Service Manual Page 54
CSIP Level 1 Safety: Mechanical Safety
Mechanical
Safety
Although the system is designed to be mobile, remember that it is very heavy, and that you must
take precautions when moving it. The physical aspects of this system present a hazard that can
cause injury, property damage, or equipment damage if the following information is ignored:
WARNINGS. • Before moving the system, be sure to power it off, remove any loose equipment from the top
of the system, disconnect the system power cord, and disconnect all external devices. Move
and secure external devices away from the system.
• Make sure the control top is locked, to prevent its pivoting and unlock the caster locks
before moving the system. Push with the handle at the front of the cart. After the system is
in position, engage the caster locks to immobilize the system.
• Be aware of the casters as well as the extremities of the system when moving it. The system
is heavy enough in any configuration that it can cause injury to you or others. Exercise addi-
tional caution when going up or down inclines.
• When attempting to overcome an obstacle, do not push the system with enough force to
cause it to tip over. Do not exceed 10 degrees of incline.
• Never park the system on an incline.
• For transport, make sure the control top is locked and secure the system so that it cannot
roll or tip. Engage the caster locks and use wheel chocks and restraining straps. Do not
attempt to hold the system in place manually. Never strap or secure the system at any point
on the control top or monitor.
To Next Page
Loading...