4535 612 10261 HD11 Service Manual Page 208
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
Peripheral Mounting Plates
Figure 10-21 Removing the Dual or Single Peripheral
Mounting Plate
Torx screws
(4 plcs)
2
Dual plate
Single plate
Mounting
plate
bracket
1
1
➤ To remove the peripheral
mounting plates
Refer to Figure 10-3 and Figure 10-4 for
left and right side panel removal before
proceeding with peripheral mounting
plate removal.
NOTE For clarity, the peripherals are
not shown in the mounted
position on the plate.
1. Remove any top-mounted peripher-
als (see “To remove the VCR, the
color printer, or both” on page 207).
2. Remove the four Torx screws secur-
ing the plate to the mounting plate
bracket.
This completes the peripheral mounting
plate removal procedure.
Return to Disassembly Procedure List (1
of 2).
To Next Page
Loading...