Philips HD11 - Figure 10-66 Removing the Video I;O Board

4535 612 10261 HD11 Service Manual Page 253
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
Figure 10-66 Removing the Video I/O Board
18
19
Standoff
screws
(8 plcs)
18. To remove the Video I/O board from
the Rear I/O splitter can, remove all
eight standoff screws securing the
four connectors at the rear of the
splitter can.
19. Slide the Video I/O board out of the
splitter can.
This completes the Rear I/O assembly
and Video I/O board removal procedure.
Perform this procedure in reverse for
reassembly.
Return to Disassembly Procedure List (2
of 2).