4535 612 10261 HD11 Service Manual Page 288
CSIP Level 1 Cabling: Introduction
11 Cabling
Introduction
This section contains system cabling and connector information. Use the illustrations (figures)
and parts tables in this section to locate and identify system cables and their part numbers. Part
numbers are shown on the illustrations and are listed and described in the corresponding tables.
NOTE Cable part numbers are located on at least one end of the cables.
CAUTION Do not connect the auxiliary power cable 453561175221 to the E-box Interface Board connec-
tor located on the back of the PC. Doing so will destroy the Rear I/O panel Video I/O card. See
Figure 11-1 for proper cabling of the system.
System
Cabling
Diagrams
System signal interconnect and power distribution cabling diagrams are shown in Figure 11-1 and
Figure 11-2, with HD11 PC internal cabling details shown in Figure 11-3. For reference, sys-
tem-to-peripheral connection diagrams are provided in Figure 11-4 through Figure 11-6.
Cable Part
Numbers
Table 11-1 is a parts list of the interconnect cables shown in Figure 11-1 and Figure 11-3.
Table 11-2 is a parts list of the power distribution cables shown in Figure 11-2 and Figure 11-3.
Refer to Table 14-3 for additional information on peripherals and applicable cables.
System
Connectors
Figure 11-7 through Figure 11-13 are illustrations of the system primary connector assemblies.
To Next Page
Loading...