4535 612 10261 HD11 Service Manual Page 230
CSIP Level 1 Disassembly and Reassembly: Disassembly Procedures
E-box Card Cage Boards
Figure 10-43 Removing the Right Side Panel
To r x s c r e w s
(2 plcs)
1
2
3
➤ To remove the E-box boards
NOTE You can perform most E-box
service without removing the
E-box from the system. Refer
to the E-box Assembly for the
removal procedure.
1. Disconnect the system power cord
from the main AC supply.
2. Remove the two Torx screws secur-
ing the right side panel enclosure.
Removing this panel allows access to
the E-box and power supply assem-
blies.
3. Pivot the back side of the panel away
from the system, and then gently
slide the panel toward the rear to
remove it. Proceed to step 4.
To Next Page
Loading...