4535 612 10261 HD11 Service Manual Page 117
CSIP: Level 2 Installation: Physical Installation Procedures
Figure 5-25 Replacing the Cable Connection Access Panel
8
Access panel tabs
8
8. Replace the cable connection access
panel by lining up the three tabs with
the slots and pressing the panel into
place. You are done installing the
monitor.
NOTE You are required to set up the
monitor when you power the
system on for the first time
(see “Setting Up the Monitor”
on page 83).
This completes the system monitor
installation procedure.
Return to Installation Procedure List.
To Next Page
Loading...