4535 612 10261 HD11 Service Manual Page 30
CSIP Level 1 General Information: More About This Manual
• Section 6, “Performance Tests”: Includes test procedures for diagnosing problems with the
system and assuring its safe and accurate operation.
• Section 7, “Adjustments”: Provides adjustment information for the system monitor. Except
for the monitor, there are no other calibration or alignment adjustments to make in the field
for this system. Except for the monitor, there are no other voltage adjustments to make in
the field for this system.
• Section 8, “Preventive Maintenance”: Identifies activities supporting the quality assurance
audit (QAA) concept that you should perform in accordance with Customer Field Service
policy.
• Section 9, “Troubleshooting”: Provides troubleshooting information that will assist you in
determining if a system is failing, and, if so, will help you isolate the cause.
• Section 10, “Disassembly and Reassembly”: Provides specific information about system disas-
sembly that may be required for the removal and installation of field-replaceable parts. If not
covered by a detailed procedure, the means of removing a system part can be discerned from
the illustrations in this section as well as from those in Section 13, “Configuration” and in
Section 14, “Parts”. Instructions for crating the system for shipment are also included.
• Section 11, “Cabling”: Provides system signal and power interconnect information, cable part
number information, and (sold-with-system) peripheral connection diagrams.
• Section 12, “Change History”: Chronicles the software and hardware changes associated
with specific software releases.
To Next Page
Loading...