VTrak E-Class Product Manual
184
To view enclosure topology:
1. From the Main Menu, highlight Subsystem Management and press Enter.
2. Highlight Enclosure Topology and press Enter.
The following information applies to the Head Unit:
• Enclosure number – 1
• Controller number – 1 or 2
•Port number
• Status – OK is normal. N/C is not connected
•Link Width
The following information applies to RAID cascaded units or JBOD
expansion units:
• Connected EnclWWN – The subsystem identified by its World Wide
Number (WWN)
• Connected(Encl,Ctrl,Port) – The subsystem’s enclosure, controller,
and port numbers where the data connection was made
If there is no connection, the value shows N/A.
To Next Page
Loading...
