Renesas RL78/G15 - 12.3 Registers to Control the Serial Array Unit

RL78/G15 CHAPTER 12 SERIAL ARRAY UNIT
R01UH0959EJ0110 Rev.1.10 Page 371 of 765
Mar 7, 2023
12.3 Registers to Control the Serial Array Unit
The following registers are used to control the serial array unit.
●
Peripheral enable register 0 (PER0)
●
Serial clock select register m (SPSm)
●
Serial mode register mn (SMRmn)
●
Serial communication operation setting register mn (SCRmn)
●
Serial data register mn (SDRmn)
●
Serial flag clear trigger register mn (SIRmn)
●
Serial status register mn (SSRmn)
●
Serial channel start register m (SSm)
●
Serial channel stop register m (STm)
●
Serial channel enable status register m (SEm)
●
Serial output enable register m (SOEm)
●
Serial output level register m (SOLm)
●
Serial output register m (SOm)
●
Input switch control register (ISC)
●
Noise filter enable register 0 (NFEN0)
●
Port output mode registers 0, 2, 4 (POM0, POM2, POM4)
●
Port mode control registers 0, 2 (PMC0, PMC2)
●
Port mode registers 0, 2, 4 (PM0, PM2, PM4)
●
Port registers 0, 2, 4 (P0, P2, P4)
Remark m: Unit number (m = 0), n: Channel number (n = 0, 1)