Renesas RL78/G15 - CHAPTER 18 OPTION BYTE; 18.1 Functions of Option Bytes

RL78/G15 CHAPTER 18 OPTION BYTE
R01UH0959EJ0110 Rev.1.10 Page 648 of 765
Mar 7, 2023
CHAPTER 18 OPTION BYTE
18.1 Functions of Option Bytes
Addresses 000C0H to 000C3H of the flash memory form an option byte area.
Option bytes consist of user option byte (000C0H to 000C2H) and on-chip debug option byte (000C3H).
Upon power application or resetting and starting, an option byte is automatically referenced and a specified function is
set. When using the product, be sure to set the following functions by using the option bytes.
Caution The option bytes should always be set regardless of whether each function is used.
18.1.1 User option byte (000C0H to 000C2H)
1) 000C0H
 Setting of watchdog timer operation
– Enabling or disabling of counter operation
– Enabling or disabling of counter operation in the HALT or STOP mode
 Time setting of watchdog timer
– Setting of overflow time of watchdog timer
– Setting of interval interrupt time of watchdog timer
2) 000C1H
 Setting of SPOR detection level (V
SPOR
)
 Controlling of P125/RESET
¯¯¯¯¯¯
/INTP1/(VCOUT0)/(VCOUT1)/(SI01)
Note 1
pin
– Select P125/INTP1/(VCOUT0)/(VCOUT1)/(SI01)
Note 1
or RESET
¯¯¯¯¯¯
.
Note 1. For 20-pin products
3) 000C2H
 Setting of the frequency of the high-speed on-chip oscillator
– Select from 1 to 16 MHz.
18.1.2 On-chip debug option byte (000C3H)
 Control of on-chip debug operation
– On-chip debug operation is disabled or enabled.