Applicable for small inertia systems which do NOT allow reverse running at the
startup and cause no change to rotor position after the system stop.
● C3.51=2: Detection at every running
Normally the checking shall be performed on the rotor initial position at each
startup. Set C3.51 to '2' for the applications which do NOT allow the reverse
running at startup and cause change to the rotor position after system stop.
Bosch Rexroth AG
Functions and Parameters
EFC x610 Series
234/389
DOK-RCON03-EFC-X610***-IT05-EN-P
To Next Page
Loading...
Need help?
General
